Bose DesignMax DM2C-LP Installation Manual page 5

PRO.BOSE.COM
Wiring the Loudspeaker
Wire Gauge
The DesignMax DM2C-LP loudspeaker is designed to work with 18 AWG (0.8 mm
Connection Diagrams
Expose six millimeters (1/4 inch)
of bare wire to attach to the
terminals.
Loudspeaker Settings
Preparing the Installation
Using a Safety Cable
Some regional construction codes require the use of a secondary method of securing loudspeakers to support structures
to provide additional safety. Choose a mounting position, method, and hardware consistent with local building codes and
regulations.
Bose recommends using (1) a safety wire or (2) a safety cable as a secondary securing mechanism. See the diagrams
below for safety attachment points.
Follow the manufacturer's instructions for any secondary securing mechanism implemented.
qw
Installation Guide • DesignMax DM2C-LP
70V/100V
1.2W
2.3W
* Factory default
Transformer Tap Setting
Set tap by turning. Use a flat head screwdriver.
) to 14 AWG (2.1 mm ) size wire only.
2 2
16Ω
70V
2.3W 4.5W
4.5W 9W
100V
** NC: No Connection (do not use)
Setup
9W*
16Ω
NC**
q
English • 5