Keyboard Commands; Setting The Camera Address; Fastaddress - Bosch series VG4-300 User Manual

4 en | Getting Started
1.2.2

Keyboard Commands

Keyboard control commands are composed of a sequence of three (3) inputs with the follow-
ing convention: 1) a Function key + 2) a Command number key(s) + 3) the Enter key.
–
NOTICE! The convention used for control key commands in this manual is ON, OFF, SET, and
i
SHOT. Refer to your keyboard manual for the key naming conventions.
–
–
For example, the keyboard command to make the AutoDome pan 360º continuously is:
1.3

Setting the Camera Address

Once the AutoDome power is turned on and homing is complete, you must set the camera
address. You may also want to assign a password and customize some of the AutoDome
default settings.
NOTICE! You do not need to set a camera address if using Bilinx or Ethernet communication.
i
See the AutoDome Installation Manual to configure an AutoDome for Bilinx or Ethernet
operation.
1.3.1

FastAddress

FastAddress is an AutoDome feature that allows you to set or change a camera address using
the keyboard and on-screen menus.
There are three (3) FastAddress commands:
–
NOTICE! If a keyboard is set to a camera number that already has an address, that camera also
i
responds to this command.
–
–
To set an address to a camera without an address:
1.
2.
3.
F01U064036 | 1.0 | 2007.01
Depending on the type of keyboard, the control function keys are labeled:
ON or AUX ON
OFF or AUX OFF
SET or SET SHOT
SHOT or SHOW SHOT
Command numbers range from 1 to 999. See Chapter 6: Keyboard Commands by Number
for a complete list of keyboard commands.
The Enter key can also be labeled with the
ON-1-ENTER
Press the ON key, then press the number 1 key, and then press ENTER.
ON-999-ENTER: Displays and programs all cameras without an address in the system.
ON-998-ENTER: Displays and programs all cameras with or without an address in the sys-
tem.
ON-997-ENTER: Displays the current address status of all cameras in the system simulta-
neously.
Select the camera number you want to FastAddress. The system displays the camera
number on the keyboard and the image on the corresponding monitor.
Press #-ENTER (where # is the camera number without an address).
Press ON-999-ENTER to invoke an on-screen display of cameras on the system without an
address.
VG4-200, VG4-300, VG4-500i Series User's Manual
AutoDome Modular Camera System
symbol.
Bosch Security Systems, Inc.