Install The Range; Electrical Connection Requirements; Anti-Tip Device Installation; Final Installation - LG LRE6327ST Installation Manual

Replace the access cover on the back of the range. To
replace the wire cover, insert the two tabs into the
openings located below the opening and tighten the
three screws.
Access cover
ELECTRICAL CONNECTION
REQUIREMENTS
The range must be installed in accordance with Local
and Canadian Electrical Codes (latest edition). See rating
plate for total connected Amp rating. This model was
shipped direct from the factory with Service cord
attached. There are no range connections necessary.
Only a range cord rated at 40 amps with 120/240
minimum volt range is required. If a 50 amp range cord
is used, it should be marked for use with 1
connection openings.

ANTI-TIP DEVICE INSTALLATION

A child or adult can tip the range and be
killed. Verify the anti-tip bracket have been
installed. Ensure the anti-tip bracket is
enganged when the range is moved.
Do not operate the range without the anti-
tip bracket in place. Failure to follow these
instructions can result in death or serious
burns to children and adults.
To check visually that leveling leg is inserted
into bracket, grasp the top rear edge of the
range and carefully attempt to tilt it forward.
/ " diameter
3
8
WARNING
Leveling
bracket
leg

INSTALL THE RANGE

Screw must
enter wood
or concrete
Anti-tip brackets are packaged with the template. The
instructions include necessar y information to
complete the installation. Read and follow range
installation instruction sheet (template).
Level the range by adjusting the leveling legs with a
wrench.
Leg
leveler
Raise
range
Use a level to check your adjustments. Place the level
diagonally on the oven rack, and check each direction
for level.
First check direction Å.
After check direction Ç.
If the level doesn't show
level on the rack, adjust
the leveling legs with a
wrench.

FINAL INSTALLATION

the receptacle.
slide under the anti-tip brackets. Range should sit flush
against the back wall when properly installed.
the anti-tip brackets are engaged properly. If properly
installed, the anti-brackets will prevent the range from
being tipped. If the range can be tipped, reinstall the
range until the brackets are properly installed and the
range will not tip forward.
operation as described in owner's manual.
9
Anti-tip
Wall plate
bracket
Lower
range
level