Table of Contents
Advertisement
Part 2
PREPARE TO INSTALL THE RANGE
2
INSTALLATION DRAWINGS (LSRE Series only)
NOTE
SAVE FOR THE USE OF THE LOCAL ELECTRICAL INSPECTOR.
CLEARANCES AND DIMENSIONS (Figure 1)
To install range refer to the following Figure 1.
For installation in CANADA, a Free-standing range is not to be installed closer than
adjacent surface.
• Make sure that the wall covering,
countertop and cabinets around the
range can withstand the heat (up to
194°F) generated by the range.
- Discoloration, delamination or melting may occur.
- This range has been designed to comply with
the maximum allowable wood cabinet
temperatures of 194°F.
A = 30"(76.2 cm) For U.S.A
= 30"(76.2 cm) ~ 31"(78.7 cm) For CANADA
MINIMUM DIMENSIONS (Figure 2)
* 30"(76.2 cm) minimum clearance between the top of the cooking surface and the bottom of an
unprotected wood or metal cabinet; or 24"(60.9 cm) minimum when bottom of wood or metal cabinet is
protected by not less than
sheet steel, 0.015"(0.381 mm) stainless steel, 0.024"(0.610 mm) aluminum or 0.020"(0.508 mm) copper.
** 15"(38.1 cm) minimum between countertop and adjacent cabinet bottom.
CAUTION
FIGURE 1
/
"(6.4 cm) flame retardant millboard covered with not less than no. 28 MSG
1
4
Tape Measure
Pencil
• Cabinet storage space located above
the surface units should be avoided.
• Install a range hood that projects
horizontally a minimum of 5 inches
beyond the bottom of the cabinets If
cabinet storage is to be provided.
- The risk of burns or fire by reaching over the
heated surface elements can be reduced.
4
Safety Glasses
15
/
(12mm) from any
32
CAUTION
Gloves
Rear filler & 2 Screws
(LSE Series only)
FIGURE 2
Ta
Advertisement
Table of Contents
