Advertisement
Ground Stacking
ICLive X series is ideally suited to portable applications.
Each ICLX and ICLXL module has a tripod socket on the
bottom of the cabinet. A single ICLXL or two ICLXs can be
supported by a standard loudspeaker tripod stand.
In addition, Renkus-Heinz subwoofers are equipped with
a 20 mm threaded socket into which threads POLE-101,
allowing the subwoofer to be the base for an ICLXL or two
ICLXs. Never put more than one ICLXL or two ICLXs on a
tripod stand or POLE-101.
For taller arrays supported on subwoofers the ICLX-GSA
ground stack adaptor plate is available.
The ICLX-GSA attaches to the subwoofer with a hand screw
using the 20 mm threaded socket. The large, single point of
attachment allows for horizontal aiming of the array without
turning the subwoofer.
1. Attach the ICLX-GSA to the subwoofer with the hand
screw and tighten securely.
2. Remove the QR pins from the ICLX-GSA and splay
them out so that they do not become trapped under
the ICLive array.
3. Set the first cabinet in the array into the ICLX-GSA,
aligning the slots in the cabinet with the tabs in the
ICLX-GSA.
4. Insert the three QR pins into the holes in the array
bars.
5. Important! Pull back on the pins to insure that
they are securely locked into place.
6. Repeat with all of the cabinets in the array.
Warning! To avoid toppling, never stack more than two
ICLX modules or one ICLXL on an SA112 subwoofer, or
subwoofer of similar size. Never stack more than four
ICLX modules or any combination of equivalent height
on an SA118 subwoofer, or subwoofer of similar size.
11
Advertisement
