Advertisement
PS
C
ANALOG COPROCESSOR PIONEER KIT
®
O
• Connect the board to your PC using the provided
USB cable
Note: This demo does not require driver
installation, although this may continue in the
background
CY8CKIT-048 QUICK START GUIDE
1
• The on-board RGB LED will turn on with
Kit Contents:
1. PSoC Analog Coprocessor Pioneer board
R
2. USB Standard-A to Mini-B cable
3. Four jumper wires (4 inches each)
4. Five connectors (one10x1, two 8x1,
one 6x1 and one 4x1)
5. One metal disk
6. Quick Start Guide (this document)
red color
2
Advertisement
Table of Contents
Related Manuals for Cypress PSOC CY8CKIT-048
Summary of Contents for Cypress PSOC CY8CKIT-048
- Page 1 CY8CKIT-048 QUICK START GUIDE ANALOG COPROCESSOR PIONEER KIT ® Kit Contents: 1. PSoC Analog Coprocessor Pioneer board 2. USB Standard-A to Mini-B cable 3. Four jumper wires (4 inches each) 4. Five connectors (one10x1, two 8x1, one 6x1 and one 4x1) 5.
- Page 2 Note 1: Bringing your nger close to the ALS hardware design les from (do not touch the sensor) obstructs the light falling www.cypress.com/CY8CKIT-048 on the sensor. Note 2: To observe the change in RGB LED intensity, keep the board in a location with good ambient light illuminance.
- Page 3 28. Current measurement jumper (J14) 12. KitProg2 status LEDs (LED1, LED2, LED3) 29. KitProg2 user button (SW3) 13. Cypress F-RAM 1 Mb (FM24V10-G, U10) 30. RGB LED (LED5) 14. Voltage Level Translator for F-RAM (U9) 31. 32.768 kHz crystal oscillator (Y1) 15.
- Page 4 P5LP1_6 P5LP_XRES P5LP0_7 P5LP0_3 P5LP_VBUS P5LP0_2 Arduino Uno R3 PSoC Analog Coprocessor Pioneer board © 2016 - 2017 Cypress Semiconductor Corporation. All rights reserved. All trademarks or registered trademarks referenced herein are the property of their respective owners. 002-11173 Rev.*D...
Need help?
Do you have a question about the PSOC CY8CKIT-048 and is the answer not in the manual?
Questions and answers