Fireye BurnerPRO BP110 Manual page 31

NO FAULT
37 INPUTS WAITING TIME FAULT
38 SUPV SW WDT RESET
39 SUPV SW RESET
40 HARDWARE RESET
41 SUPV HARDWARE RESET
42 MAIN LOOP STUCK FAULT
43 SUPV LOOP STUCK FAULT
44 SUPV TIMER2 FAULT
45 MAIN AC PEAK MISSING FAULT
46 SUPV AC PEAK MISSING FAULT
47 UV PULSE INPUT MISSMATCH
48 SUPERVISORY MCU ADC FAULT
49 MAIN MCU ADC FAULT
50 IGNITION FEEDBACK FAULT
51 PILOT_FEEDBACK_FAULT
52 MAINP_FEEDBACK_FAULT
53 FEEDBACK_WAITING_TIME_EXPIRE
54 MAIND_FEEDBACK_FAULT
55 INTERRUPT DIAG FAULT
56 FALSE_FLAME_ERROR
57 POWERON_FALSE_FLAME_ERROR
58 OPEN_FEEDBACK_READING_FAULT
59 ADJACENT PIN SHORT FAULT
60 LOCAL RESET DEBOUNCE FAULT
61 POC OPEN FAULT
62 STRONG UV FLAME FAULT
63 SPI CRC FAULT
System was unable to satisfy combustion air switch test and/or proof of closure during a burner sequence. Check wiring.
Check air-flow switch.
Internal software reset by Microcontroller. Contact distributor/factory if error persists.
Internal software reset by Microcontroller. Contact distributor/factory if error persists.
Replace control. Contact distributor/factory if error persists.
Replace control. Contact distributor/factory if error persists.
Replace control. Contact distributor/factory.
Replace control. Contact distributor/factory.
Replace control. Contact distributor/factory.
Check Mains voltage. Contact distributor/factory.
Check Mains voltage. Contact distributor/factory.
Replace control. Contact distributor/factory.
Replace control. Contact distributor/factory.
Replace control. Contact distributor/factory.
System detected voltage on terminal 16 at the wrong time or voltage is not present when needed. Check wiring and make
sure grounding is adequate.
System detected voltage on terminal 17 at the wrong time or voltage is not present when needed. Check wiring and make
sure grounding is adequate.
System detected voltage on terminal 19 at the wrong time or voltage is not present when needed. Check wiring and make
sure grounding is adequate.
Loss of actuator feedback for more than 10 minutes. Check wiring. Check modulation equipment.
System detected voltage on terminal 18 at the wrong time or voltage is not present when needed. Check wiring and make
sure grounding is adequate.
Replace control. Contact distributor/factory.
False flame detected before Ignition. Check wiring. Check scanner. Make sure grounding is adequate.
False flame detected at power on. Check wiring. Check scanner. Make sure grounding is adequate.
System detected voltage on terminal 8 at the wrong time or voltage is not present when needed. Check wiring and make
sure grounding is adequate.
Replace control. Contact distributor/factory.
Local reset button held for more than 10 seconds or reset button is stuck.
Fuel valve is open at the wrong time OR check wiring
Scanner too close to flame. Add distance between scanner and flame OR use orifice to reduce field of view.
Replace control. Contact distributor/factory
POSSIBLE REMEDY
®
31