Table of Contents
Advertisement
Radio Frequency Interference Requirements
This device has been tested and found to comply with the limits for a Class A digital
device pursuant to Part 15 of the Federal Communications Commissions Rules and
Regulation. These limits are designed to provide reasonable protection against harmful
interference when the equipment is operated in a commercial environment. This
equipment generates, uses, and can radiate radio frequency energy and, if not installed
and used in accordance with the instruction manual, may cause harmful interference to
radio communications. Operation of this equipment in a residential area is likely to cause
harmful interference in which case the user will be required to correct the interference at
his own expense.
However, there is no guarantee that interference will not occur in a particular installation.
If the equipment does cause harmful interference to radio or television reception, which
can be determined by turning the equipment off and on, the user is encouraged to try to
correct the interference by one or more of the following measures:
•
Re-orient or relocate the receiving antenna.
•
Increase the separation between the equipment and receiver.
•
Connect the equipment into an outlet on a circuit different from that which the
receiver is connected.
•
Consult the dealer or an experienced radio/TV technician for help.
Radio Frequency Interference Requirements -
Canada
This Class A digital apparatus meets the requirements of the Canadian Interference-
Causing Equipment Regulations.
Cet appareil numérique de la Classe A respecte toutes les exigences du Reglement sur le
Materiél Brouilleur du Canada.
CE Marking and European Union Compliance
Products intended for sale within the European Union are marked with the CE Mark which
indicates compliance to applicable Directives and European Normes (EN), as
follows. Amendments to these Directives or ENs are included:
Applicable Directives:
•
Electromagnetic Compatibility Directive 89/336/EEC
•
Low Voltage Directive 73/23/EEC
Applicable Standards:
•
EN 55 022 - Limits and Methods of Measurement of Radio Interference Char-
acteristics of Information technology Equipment
•
EN 50 082-1 - Electromagnetic Compatibility - Generic Immunity Standard,
Part 1: Residential, commercial, Light Industry
•
IEC 801.2 - Electromagnetic Compatibility for Industrial Process Measurement
and Control Equipment Part 2: Electrostatic Discharge Requirements
•
IEC 801.3 - Electromagnetic Compatibility for Industrial Process Measure-
ment and Control Equipment Part 3: Radiated Electromagnetic Field
Requirements
•
IEC 801.4 - Electromagnetic Compatibility for Industrial Process Measurement
and Control Equipment Part 4: Electrical Fast Transients Requirements
Quick Reference
19
Advertisement
Table of Contents
