Air Conditioner Features; Care And Cleaning - Kelvinator KWH15CME User Manual

Air conditioning features
Note: When turning the SELECTOR knob from "LOW COOL" to "HIGH COOL", change as slowly as possible. Do not
change the operation mode between "LOW COOL" and "HIGH COOL" too often.
Thermostat
To set the desired room temperature, rotate the thermostat switch to the desired setting. After the set temperature
is achieved the thermostat will automatically start and stop the compressor in order to maintain the desired set
temperature.
Rotate the thermostat selector clockwise for higher cool settings. Higher cool settings will provide lower room
temperature. Rotate the thermostat selector counter clockwise for lower cool settings. Lower cool settings will
provide higher room temperature.
The thermostat is used to set the desired room temperature when the unit is being operated in the COOL MODE.
NOTE: During the cooling operation of the unit, when the thermostat knob is rotated clockwise, allow at least three
minutes before turning back the knob to the COOLER direction. Otherwise the fuse may blow due to an
overload of the unit.
Adjusting the air flow direction
Horizontal air flow adjustment
For the units with AIR SWING feature (automatic):
When the AIR SWING switch is turned to ON position, the vertical louvres automatically oscillate right and left
sweeping the cold air around to obtain comfortable cooling. The vertical louvres may be stopped at any position
when the AIR SWING switch is turned OFF.
For the units without AIR SWING feature (manually ):
To adjust horizontal air flow direction, move the lever gently to the left or right by hand until the desired horizontal
air flow direction is obtained.
Vertical air flow adjustment (manually)
To adjust vertical air flow direction, adjust any one of the horizontal louvre blades. When turning up or down the
horizontal louvre blades, always keep horizontally the top or bottom blades. This can effectively prevent water drops
condensed on the front panel of the unit.
Vent control
The vent control is located above the control knobs. The operation method is different on different models (see the
following figures).
For maximum cooling efficiency, CLOSE the vent. This will allow internal air circulation.
OPEN the vent to discharge stale air.
close
open
CLOSE
OPEN
To open the vent, push the lever to the right. To close it, push the lever to the left.
caution
Clean your air conditioner occasionally to keep it looking new. Be sure to unplug the unit before cleaning to prevent
shock or fire hazards.
Air filter cleaning
AUTO SWING
OFF ON
(On somemodels)

Care and cleaning