MPAA Rating ......................................13 Television Rating Guides ..................................13 Auxiliary Block Source ..................................14 Parental Lock ....................................... 14 Power on Channel ....................................14 www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Page 3
Standby Power ..................................... 19 Cloning/Firmware/Splash Updates ..............................19 MTI/SmartPort Personality ................................... 20 Security ......................................... 21 Support Information ..................................... 21 Limited Warranty ....................................................21 www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Page 4
The information contained herein is believed accurate, but is not warranted, and is subject to change without notice or obligation. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
à oxygène. Une telle utilisation peut causer operate from battery power, or other sources, refer to the un risque d'incendie. operating instructions. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Installation Precautions For Power over Coax, use only a power source from PDi suitable for use in a healthcare facility. The single coaxial cable on top of the TV is used to supply both low voltage AC or DC power (28VAC or 24VDC) and RF signal to the television, UNLESS the unit is powered over ethernet.
Note: The following instructions assume you have a programming remote, have correctly mounted the TV, and connected a coax cable that provides both power and RF signal. The PDi programming remote Part Number PD108-420 must be ordered separately. If the blue SETUP screen goes blank while you are changing any settings, simply press SETUP on the PD108-420 remote.
In Sound menu, press the CH▲ / CH▼ to select Minimum Volume. Press the VOL◄ / VOL► to select your preferred minimum volume. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
In the Sound menu, press CH▲ / CH▼ to highlight Headphone Sound Mode. Press VOL ◄ / VOL ► to choose between settings. Press SETUP to return to previous menu. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
SETUP to return to normal TV viewing. NOTE: Any tuning mode that includes Digital channels will require several minutes to complete the auto programming. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
NOTE: After a Service Level is cleared, the TV returns to the Clear Service Level menu. “Blank” will appear to the right of the Service Level. Press SETUP to return to the previous menu. To exit, press SETUP until the programming menus disappear. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
NOTE: Categories that are rated for older audiences will be automatically blocked. If you block TV-Y category, then TV-Y7 will be blocked automatically. Similarly, if you block TV-G category, then TV-PG, TV-14 and TV-MA will also be blocked. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Language, Sex, and Violence Scenes. TV-MA Mature Audience Only Adults only, may contain: Strong Dialogue, Bad Language, Sex, and Violence Scenes www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Press VOL ◄ or VOL ► to select Enable or Disable. Press SETUP to return to the previous menu. To exit, press SETUP until the programming menus disappear. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
The patient remote can be toggled between Bed A, Bed B, Bed C, and Bed D codes by using a paperclip to press the CODE button on the remote. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Digital Mode Time Setup The current time will be set automatically from a digital channel signal provided by a broadcasting TV station. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
Press CH▲ or CH▼ to select the OSD Language menu (English, French, Spanish). Press VOL ◄ or VOL ► to select your desired language. www.pdiarm.com www.mymedTV.com PDi Communication Systems, Inc. ▪ 40 Greenwood Ln ▪ Springboro, Ohio 45066 USA ▪ ▪ Phone 800.628.9870...
TV to a USB memory stick (thumb drive) and then uploading the setup information to another TV. Alternatively, clone files can be loaded to the RF-HEMiS Head-end TV Server by PDi and distributed to other TVs.
The firmware is field upgradeable, but normally does not require this process and should be performed by the hospital technician. A special data file is required from the PDi factory to complete this process. Firmware files are written to the root directory of a USB Flash Drive, connected to the TV’s Cloning port and updated using the TV’s menus.
PDi Communication Systems Inc., (“PDi”) standard warranty information is found at pdiarm.com. For information regarding authorized servicing and all other information pertaining to this warranty, please contact PDi COMMUNICATION SYSTEMS, INC. at 40 Greenwood Ln, Springboro, Ohio 45066 or phone 800-628-9870 and ask for the PDi ProServices team.