Table of Contents
Advertisement
This guide is provided as a help and not a total solution for every installation.
Common sense and concern for customers equipment will make for a good installation.
• The Positive lead for the power line is Red and comes from a 12-volt power source such as a 12 volt accessory
plug 2 Amp Min (prefer 3 Amp).
• The Control Cable connects to the dish on the roof.
• The Serial Cable connects to the computer.
• The "To Modem" line goes to the splitter.
There are only 4 cables that attach to the back of the DIRECWAY modems.
1.
The far-left white cable is the USB cable that attaches to the computer.
2. The black circular cable is the modems power supply.
3. The top right Coax Cable is the Receive Modem that
connects to the splitter (see wiring diagram).
4.
The bottom right Coax Cable is the Transmit cable that is connected directly to the DirecWay satellite dish.
STEP 10. CONNECTING COMPUTER
Connect the Serial cable from Main Controller and locate the USB cable from the modem. The other cable in this picture is
the power cable for the laptop.
Note: Air circulation is
required to prevent
premature or
intermittent failure due
to overheating.
to provide proper
ventilation may void
warranty.
23
Failure
Advertisement
Table of Contents
