Table of Contents
Advertisement
This guide is provided as a help and not a total solution for every installation.
Common sense and concern for customers equipment will make for a good installation.
If you need to manually move the dish, you may do so by removing the 9-pin connector from the back of the main
controller. Then, using a small screwdriver, remove the wires from the connector and plug in certain colors into the 12-
volt power lead that powers the main controller.
ORANGE & RED wires - raise and lower the dish (Elevation).
BROWN & BLACK wires - rotate the dish (Azimuth).
BROWN AND RED wires - tilt the dish face (Skew).
Simply reverse the wires to make the movement reverse.
22
Advertisement
Table of Contents
