Table of Contents
Advertisement
This guide is provided as a help and not a total solution for every installation.
Common sense and concern for customers equipment will make for a good installation.
Use Zip ties to secure wires to each other.
Spend time to assure a watertight seal where the cables enter the vehicle. Squeeze Dicor between the cables as well.
Connect cables to dish mount to complete the install on top of roof and secure the cable with cable clamps inside the
vehicle in inconspicuous areas.
STEP 9. CONNECTING MAIN CONTROLLER & MODEMS
Cut the control cable to length once it has been pulled inside the vehicle. Remove 2" of the plastic cover to expose the
wires.
Use "Clam Shell" provided to
cover cable entry hole. Use sealant
under shell to seal entry.
Recommended
20
Advertisement
Table of Contents
