Place The Mounting Plate And Screw Into Place - MotoSAT DataStorm Installation Manual

This guide is provided as a help and not a total solution for every installation.
Common sense and concern for customers equipment will make for a good installation.
Lift the Mounting Plate, and Pre-Fill all holes to be used.
Note: When pre drilling, drill and then fill the hole, when using self-tapping screws, use the technique shown above.
STEP 6. PLACE THE MOUNTING PLATE AND SCREW INTO PLACE
CAREFULLY move the mounting plate over holes and slowly drop it into place. Center the holes over each marking and
press down slightly on plate. Once centered, attach the plate to the roof with short screws.
NOTE - In the illustrated installation, the roof is rubber on top of a wood foundation.
Note:
The Mounting Plate comes
with predrilled holes. When securing
the mount to the roof, use as many of
the holes as required for the job.
Know your roof structure and
capabilities.
12