Honda HSM1336i Owner's Manual page 67

 Turn on the spot (Steering lever fully squeezed)
Fully squeezing a steering lever causes the two tracks to move in
opposite directions, which makes the snow blower turn on the spot
(corrects the direction on the spot).
CENTER OF SNOW BLOWER
OPERATOR
CENTER OF TURN
OPERATOR
Drive motor control protection system
This snow blower is designed to drive using electric motor power.
When an excessive load is applied to the motor, which depends on an
operation condition of the snow blower, the protection circuit is
armed making the drive control warning indicator (orange) come on
and blink and possibly slow down or stop the snow blower.
If this symptom occurs, release the drive clutch lever and stop the
work. Keep the engine switch in the ON position and wait until the
drive control warning indicator (orange) does not blink. If the drive
control warning indicator (orange) goes off, it indicates that the snow
blower has been restored to its normal condition and you can
continue clearing snow.
Note that the protection system functions frequently if the motor is
under an excessive load. Adjust the load to a proper level.
The snow blower might be faulty if the engine does not restart or the
drive control warning indicator (orange) blinks when restarting the
engine. Move the snow blower to a safe place by removing the wheel
pins from the tracks and check troubleshoot the problem by referring
to the symptom-to-troubleshooting table (see pages 118 and 119).
Have your authorized Honda snow blower dealer check and repair
your snow blower if necessary.
See page 130 for wheel pin removal.
STEERING LEVER
Track turns in
the reverse
direction.
OPERATION
(Squeeze fully)
Track turns in
the normal
direction.
65