Honda HSM1336i Owner's Manual page 34

CONTROLS & FEATURES
AUGER HOUSING
CONTROL SWITCH
AUGER CLUTCH SWITCH
ON
OFF
ENGINE SWITCH
If you cannot change the initial position properly or if you want to
return the initial position to the factory set position, consult with your
authorized Honda snow blower dealer.
32
– 4.Operate the auger housing control
switch to set the auger housing in
position you want.
– 5.Push the auger clutch switch. The
reset switch indicator goes off and
the initial position is changed.
• If the reset switch indicator does
not go off when you push the
auger clutch switch, the initial
position has not been changed. Set
the auger housing in a lower
position (step 4), and then push the
auger clutch switch again.
– 6.Turn the engine switch to the OFF
position.
• Note that you cannot operate the
snow blower without turning the
engine switch to the OFF position
once.