Related Manuals for Honda HSS760A
Summary of Contents for Honda HSS760A
- Page 1 Dealer Instructions SETUP PRE-DELIVERY SERVICE HSS760A • HSS970A • HSS1380A SNOWBLOWERS © 2015 American Honda Motor Co., Inc.—All Rights Reserved PPD54651EU.2015.05...
-
Page 2: For Your Safety
HSS760A • HSS970A • HSS1380A SNOW BLOWERS IMPORTANCE OF PROPER SETUP AND PRE-DELIVERY SERVICE FOR YOUR CUSTOMER’S SAFETY Proper setup and pre-delivery service are essential WARNING to the customer’s safety and the reliability of the snowblower. Any error or oversight made during... -
Page 3: Standard Torque Values
Proper setup and pre-delivery service are essential for safe, reliable operation. Your customer expects his or her Honda snowblower to be correctly assembled, adjusted, and ready for use; test the snowblower to be sure that it functions properly. Fill out the Power Equipment Pre-Delivery Check List (TO056) and give the yellow copy to the customer. -
Page 4: Loose Parts
HSS760A • HSS970A • HSS1380A SNOW BLOWERS LOOSE PARTS Remove the crate cover and open the parts carton. Remove all the parts from the carton. Check the parts against this list. Description Quantity Part Number Illustration Owner s Manual SNOWBLOWER HS928・HS1332... -
Page 5: Pre-Delivery Inspection Checklist
HSS760A • HSS970A • HSS1380A SNOW BLOWERS SETUP 1. (ETD, EWD) Check battery voltage and recharge if lower than 12.9 V. HSS1380A HSS760A, HSS970A NEGATIVE (–) TERMINAL POSITIVE (+) NEGATIVE (–) TERMINAL CABLE PRE-DELIVERY INSPECTION CHECKLIST Refer to the owner’s manual or shop manual for more detailed procedures if necessary. - Page 6 HSS760A • HSS970A • HSS1380A SNOW BLOWERS Refer to the owner's manual for facts about oxygenated fuels. 4. (EW, EWD): Check tyre air pressure and inflate to 138 kPa if necessary. NOTICE Over-inflating the tyres may damage the tyres and cause the snowblower to pull to one side.
- Page 7 HSS760A • HSS970A • HSS1380A SNOW BLOWERS Measure the scraper bar ground clearance. If needed, SCRAPER BAR GROUND CLEARANCE adjust by loosening the five 8 mm flange nuts and the two 8 x 16 mm bolts. Evenly set the scraper bar to obtain the specified clearance.