Required Tools And Equipment; Installation Steps - Dell Networking W-7024 Installation Manual

ATTENTION: Chaque contrôleur W-7024 doit disposer de son propre équipement de montage. Veillez à ne placer aucun autre
équipement réseau directement sur un contrôleur W-7024 installé. Dans le cas contraire, vous risqueriez d'endommager le
périphérique.

Required Tools and Equipment

The following tools and equipment are required for installing a W-7024 controller from the middle of the device:
Mid-mount brackets (x2) (included in the mounting accessory kit)
l
Screws for the mounting brackets (x8): M4 x 8 mm Phillips Flat Head Screws
l
Screws for system rack mount (x4): M6 x 15 mm Phillips Pan Head Screws
l
M6 cage nut (x4): Optional
l
M6 clip nut (x4): Optional
l
Suitable screwdrivers for all screw types (not included in the package)
l
NOTE: Some racks require screws that differ from those included with the W-7024 controller. Ensure to have the correct screws
before installing the W-7024 controller.

Installation Steps

To install a W-7024 controller from the middle in a standard two-point 19-inch rack system:
1. Place the mid-mount brackets over the mounting holes on either side of the controller in the middle (see
9).
Figure 9:
Mid-Mount Brackets
2. Secure the brackets to the controller using the eight screws for mounting bracket (four per bracket) and a suitable
screwdriver.
3. If the rack requires cage nuts or clip nuts, insert them on the front rails (two per rail, aligned horizontally).
4. Mount the controller in the rack using the four screws for system rack mount (two per bracket) and suitable
screwdriver (see
21 | Installation
Figure 10).
Dell Networking W-7024 Controller | Installation Guide
Figure