Table of Contents
Advertisement
STATUS— Placed on the top right of the port, this LED displays the status of the port. The information
l
displayed by this LED changes based on the LCD mode. The LED behavior corresponding to each LCD mode
is listed in
Table
Table 6:
10GBASE-X Port LEDs
LED
Function
LINK/ACT
Link status
STATUS
Port status
SFP/SFP+ Modules and DAC Cables
SFP/SFP+ modules, also known as mini-GBICs, are hot-swappable and provide optical or copper connections to
other devices.
Direct attach cables (DACs) are installed in an uplink port in the same manner as an SFP/SFP+ module.
For the list of Dell approved DAC cables and SFP/SFP+ modules for controllers, see
NOTE: Other non-approved third-party optics or DAC cables are not tested or supported by Dell on controllers; therefore, Dell does
not guarantee their proper functionality when used with Dell controllers.
For information on how to install an SFP/SFP+ module or a DAC cable, see
page
25.
Table 7:
Supported DAC Cables
DAC
DAC-SFP-10GE-50CM
DAC-SFP-10GE-1M
DAC-SFP-10GE-3M
DAC-SFP-10GE-5M
DAC-SFP-10GE-7M
Dell Networking W-7024 Controller | Installation Guide
6.
LCD Mode
NA
Administrative
Duplex
Speed
Description
50cm Direct Attach Cable; 10G SFP+
1m Direct Attach Cable; 10G SFP+
3m Direct Attach Cable; 10G SFP+
5m Direct Attach Cable; 10G SFP+
7m Direct Attach Cable; 10G SFP+
Indicator
Status
Green (Solid)
Link established
Green (Blinking)
Port is transmitting or receiving data
Off
No link
Green (Solid)
Port enabled
Off
Port administratively disabled
Green (Solid)
Full-duplex
Off
NA
10 Gbps
Green (Solid)
Off
1 Gbps
Table 7
and
Table
"Installing an SFP/SFP+ Module" on
W-7024 Controller | 12
8.
Advertisement
Table of Contents
