License Plate Light; Supporting The Motorcycle - Yamaha Tenere 700 Owner's Manual

1. Turn signal light bulb
3. Insert a new bulb into the socket,
push it in, and then turn it clock-
wise until it stops.
4. Install the lens by installing the
screw. NOTICE: Do not over-
tighten the screw, otherwise the
lens may break.
[ECA11192]
Periodic maintenance and adjustment

License plate light

1
If the license plate light does not come
on, have a Yamaha dealer check the
electrical circuit or replace the bulb.
EAU24331

Supporting the motorcycle

1. Motorcycle jack
Since this model is not equipped with a
centerstand, use a motorcycle jack
when removing the front or rear wheel
or when performing other maintenance
that requires the motorcycle to stand
upright.
To elevate the vehicle
1. Remove cowling A. (See page
2. If necessary, insert a piece of
6-34
1
6-9.)
wood between the motorcycle
jack and the engine crankcase.
Then lift the vehicle just enough to
raise the wheels from the ground.
NOTICE: Do not lift the motorcy-
EAUM4210
6