Yamaha Tenere 700 Owner's Manual page 28

Instrument and control functions
Right
3
1. Engine stop switch "
2. "SELECT" switch
3. Start switch " "
Pass switch "PASS"
Press this switch to flash the headlight.
TIP
When the dimmer switch is set
to " ", the passing switch has no ef-
fect.
Dimmer switch " /
Set this switch to "
beam and to " " for the low beam.
TIP
When the switch is set to low beam,
both headlights for low beam come on.
When the switch is set to high beam,
both headlights for high beam and
both headlights for low beam come on.
1
Turn signal switch "
To signal a right-hand turn, push this
2
switch to "
turn, push this switch to "
3
released, the switch returns to the cen-
ter position. To cancel the turn signal
/ "
lights, push the switch in after it has re-
turned to the center position.
EAU12362
Horn switch "
Press this switch to sound the horn.
Engine stop switch "
Set this switch to "
starting the engine. Set this switch
to "
of an emergency, such as in the event
EAUM4180
"
of an overturn or if the throttle is stuck.
" for the high
/ "
". To signal a left-hand
". When
"
/ "
" (run) before
" (stop) to stop the engine in case
3-13
Start switch " "
Push this switch to crank the engine
with the starter. See page 5-2 for start-
ing instructions prior to starting the en-
EAU12461
gine.
Hazard switch " "
With the key in the "ON" or "
tion, use this switch to turn on the haz-
ard lights (simultaneous flashing of all
turn signal lights).
The hazard lights are used in case of an
emergency or to warn other drivers
EAU12501
when your vehicle is stopped where it
might be a traffic hazard.
NOTICE
EAU12663
Do not use the hazard lights for an
extended length of time with the en-
gine not running, otherwise the bat-
tery may discharge.
"SELECT" switch
This switch has the same functions as
the bottom set button of the Multi-
function meter unit.
EAU12713
EAU12735
" posi-
ECA10062
EAUM4090