Menu Level 3: Operating Mode - Waeco CoolAir CA-800-DAF Installation Manual

CA-800-Install.book Seite 35 Mittwoch, 4. Juli 2007 3:05 15
CoolAir

6.3.4 Menu level 3: Operating mode

The system always starts with a defined operating mode for room temper-
ature. This parameter can be configured:
➤ Start configuration mode (see chapter "Start and end configuration
✓ The first digit of the display (see fig. 10 on page 6, Pos. 5) shows the
➤ Press the + button (see fig. 10 on page 6, 6) twice to switch to menu
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
✓ The digits in the display flash until the parameter you enter is con-
➤ Use the buttons + or - (see fig. 10 on page 6, Pos. 6 and 7) to select
➤ Press the operating mode button (see fig. 10 on page 6, Pos. 4) to
✓ The set value is saved and is then used when the system is restarted.
✓ You are now in menu level 3 and can use the + and - buttons to switch
mode" on page 33).
menu level and the second and third show the parameter which can
be set.
level 3.
change the parameter.
firmed.
the operating mode with which the system starts.
ID number
0
1
2
3
confirm your entry.
between menu levels.
Installation
Operating mode
Automatic mode
Operating mode 1
Operating mode 2
Operating mode 3
35