Installation; Installation Instructions - Waeco CoolAir CA-800-DAF Installation Manual

CA-800-Install.book Seite 27 Mittwoch, 4. Juli 2007 3:05 15
CoolAir
6

Installation

The roof air conditioner may only be installed by qualified personnel from a
specialist company. The following information is intended for technicians
who are familiar with the guidelines and safety precautions to be applied.
6.1

Installation instructions

These installation instructions must be read completely prior to the installa-
tion of the roof air conditioner.
The following tips and instructions must be observed while installing the
roof air conditioner:
Make sure that all electrical components are electrically discharged before
carrying out work on them!
You should always check whether any vehicle components could be
damaged or their function impaired by installing the roof air conditioner
before doing so. Using Fig. 1 on page 3 you can check the dimensions
of the installed system. The broken line here shows the middle of the
roof hatch.
Before installation, find out (by consulting the manufacturer of the vehi-
cle) whether the construction is designed for the static weight and the
loads of the air conditioner when the vehicle is in motion. The manufac-
turer of the roof air conditioner (WAECO) assumes no liability whatso-
ever.
The roof inclination of the mounting surface may not be more than 8° to
the front and 0° to the rear.
The supplied assembly parts may not be modified by the customer
when installing them.
Improper installation of the roof air conditioner can result in irreparable
damage to the device and put the safety of the user at risk.
If the roof air conditioner is not installed according to the manufacturer's in-
structions, WAECO does not assume any liability. Waeco assumes no lia-
bility for malfunctions or for the safety of the roof air conditioner, especially
for personal injury and/or damage to property.
All connections to the battery of the vehicle should be disconnected before
installing the roof air conditioner.
Non-observance of this regulation can result in danger of electrocution.
Installation
27