Secure The Balance Plate; Attach The Sealing Compound To The Roof Of The Driver's Cabin; Install The System In The Roof Hatch - Waeco CoolAir CA-800-DAF Installation Manual

CA-800-Install.book Seite 29 Mittwoch, 4. Juli 2007 3:05 15
CoolAir

6.2.3 Secure the balance plate

➤ Position the balance plate on the system. To do this, place the four
The balance plate adjusts the roof air conditioner to the specific require-
ments of each vehicle.
➤ Screw one M8 nut each + spring washer + washer (see fig. 3 on
➤ Screw one M8 bolt each (see fig. 5 on page 4, Pos. 1) on to the four
6.2.4 Attach the sealing compound to the roof of the driver's
cabin
Make sure that the surface for sticking sealing compound between the bal-
ance plate and the roof of the driver's cabin is clean (free from dust, oil,
etc.).
➤ Stick the 2.5 m long insulating tape (XF95 = 25 x 25 mm, XF105 = 25
➤ Apply a plastic, non-hardening sealing compound (for example, Sika-

6.2.5 Install the system in the roof hatch

➤ Position the fastening holder under the roof of the driver's cabin (see
The fastening holder must be positioned on a firm surface, as the system
is pushed through the holder against roof of the driver's cabin. The surface
for applying the fastening holder must be at least 40 mm on each side.
➤ Position the system in the sunroof opening centrally and in the direc-
thread bolts through the four slots in the balance plate.
page 3, Pos. 1-3) on to the four thread bolts.
Handtighten the nuts.
thread bolts until just in front of the already installed nut. The nut you
have now installed is used later to hold against the fastening holder
(see fig. 5 on page 4, Pos. 2).
x 10 mm) along the contour of the roof hatch on the roof of the driver's
cabin (see fig. 4 on page 4).
Lastomer-710) to the impact edge and the top edge of the insulation
tape.
fig. 6 on page 5). The fastening holders are pushed here between the
roof of the driver's cabin (chassis) and the roof interior.
tion of travel (see fig. 1 on page 3). The four thread bolts (see fig. 3 on
page 3, Pos. 6) must be placed into the four drill holes of the fastening
holder (see fig. 5 on page 4, Pos. 2).
Installation
29