Mounting The Ait Library In The Rack - Sony StorStation ACY-RK2 Operating Instructions Manual

Mounting the AIT Library
in the Rack
Insert the library into the rack, and then secure the
brackets.
Caution
With a single drive installed, the AIT library weighs
approximately 18 kg/39.7 lbs. (With two drives
installed, the AIT library weighs approximately 19 kg/
41.9 lbs.)
At least two people are needed in order to handle the
library. Handling the AIT library on your own could
result in back injury or other accidents resulting in injury
or damage to the AIT library.
1
Pull the straight rails out from the rail assemblies.
2
Have two or more people lift the library, fit the inner
rails into the rail assemblies, and then slide the
inner rails to the locking arm position.
The library will not slide past the locking arm
position.
Inner rail
14

Mounting the AIT Library in the Rack

Rail assembly
Locking arm
3
Press the locking arm to release the lock, and then
slide the library all of the way into the rack.
4
Hand tighten the screw on one of the L-shaped
brackets on the front of the rack so that the library
is held in place.
5
Hand tighten the screw on the other L-shaped
bracket.
6
Confirm that the library is housed properly in the
rack.
7
Tighten the B screws on all of the brackets.
Locking arm
Fastener