Preparing The Rack - Sony StorStation ACY-RK2 Operating Instructions Manual

3
Remove the A caps and replace them with the B
caps.
Removing the A Caps
While pressing the A cap inward with your finger,
use the Allen wrench to loosen the set screw and
remove it.
A cap
Allen wrench
Installing the B Caps
Insert a set screw into the B cap, then align the B
cap with the pin in notch D on the front panel and
insert the B cap into notch D. After confirming that
notch D and the set screw are properly aligned, use
the Allen wrench to tighten the set screw while
pressing the B cap inward with your finger.
B cap
Set screw
4
Return the front panel to its original position.
5
Use a Philips screwdriver to remove the screws on
one side of the library.
12
Preparation
notch D
6
Use two A screws to mount an L-shaped bracket on
the side of the library as shown in the diagram.
7
Mount the L-shaped bracket on the other side of the
library in the same manner.
Mounting the Inner Rails
1
Use three D screws to mount an inner rail on the
library.
Inner rail
2
Mount the other inner rail on the other side of the
library in the same fashion.

Preparing the Rack

Mount the brackets and rail assemblies on the rack.
Mounting the Brackets
Mount the brackets that hold the rail assemblies in place
on the rack. Hand tighten the screws at first; after
confirming that the library can be mounted, tighten the
screws completely.
1
Decide where the brackets are to be mounted.
We recommend using a marker to mark the position
where each bracket is to be mounted. Note that if
the four brackets are not mounted at the correct
height, it will be impossible to mount the library.
D screw