Flat Panel Mount Location; Mounting Bracket Positioning - Sony SFM-1 Installation Manual

Flat Panel Mount Location

WARNING: INVERT THE FLAT PANEL PLACE IT ON A SOFT, FLAT SUFRACE TO PREVENT DAMAGE TO
THE FLAT PANEL. USE A BLANKET, FOAM, ETC. FAILURE TO DO SO WILL RESULT IN
DAMAGING THE FLAT PANEL. DO NOT LAY THE FLAT PANEL ON THE FLOOR WITHOUT ANY
PROTECTION TO THE GLASS. THE FLAT PANEL IS HEAVY AND FRAGILE. AT LEAST (2)
QUALIFIED PERSONNEL ARE STRONGLY RECOMMENDED FOR INSTALLATION OF THIS
PRODUCT. FAILURE TO DO SO COULD RESULT IN SERIOUS INJURY AND POSSIBLE DAMAGE
TO THE FLAT PANEL.
1. Once the flat panel is inverted, use a measuring tape to find the center of your flat panel measuring
from outside to outside of the chassis (Figure 1).
2. Using a pencil lightly mark the center of your flat panel (Figure 2).
Measuring Tape
Figure 1. Flat Panel Mount Location

Mounting Bracket Positioning

1. Install the nylon spacers to the mounting points on the flat panel (Figure 3)
2. Lay the left and right mounting brackets (stamped arrows facing out) (Figure 4).
Page 6
Top of Flat Panel
Inverted Flat
Panel
C L
Bottom of Flat
Panel
Mark the Center
of the Flat Panel
Figure 2. Marking the Mount
SFM1
Inverted Flat
Panel
L C
Installation Manual