Removing The Library From The Rack - Sony StorStation ACY-RK2 Operating Instructions Manual

Do not forget to tighten the B screws in the back of
the rack.
8
Tighten the screws on the L-shaped brackets that
were hand tightened in step 4.
9
Attach the side covers on both sides of the library's
front.
Fit the side covers' A notches over the B caps and
push them as far as they will go in the direction of
the arrow.
A notch
Side cover
Once the library is mounted in the rack, connect the
power cord and the SCSI cables and make all
necessary settings as described in the operating
instructions (PDF).
B screw
Fastener
B caps
Side cover
Removing the Library
from the Rack
Caution
With a single drive installed, the AIT library weighs
approximately 18 kg/39.7 lbs. (With two drives
installed, the AIT library weighs approximately 19 kg/
41.9 lbs.)
At least two people are needed in order to handle the
library. Handling the AIT library on your own could
result in back injury or other accidents resulting in injury
or damage to the AIT library.
1
Turn off the library.
To turn the power off, press the power standby
switch on the front panel, and then press the rear
power switch.
2
Disconnect all of the cables.
3
Remove the side covers on both sides of the front
panel.
Side cover
4
Loosen the screws in both of the L-shaped brackets.
5
Pull the library out of the rack.
6
If necessary, remove the rail assemblies and
brackets from the rack.
7
If necessary, remove the inner rails and L-shaped
brackets from the library and replace the B caps with
the A caps by reversing the procedure on page 12.

Removing the Library from the Rack

Side cover
15