Installation - Zanussi ZWT 71401 WA User Manual

After the check, activate the appliance. The
programme continues from the point of interruption.
If the problem occurs again, contact the Authorised
Service Centre.
If the display shows other alarm codes. Deactivate
and activate the appliance. If the problem
continues, contact the Service.

INSTALLATION

WARNING! Refer to Safety chapters.
UNPACKING
Remove all transit bolts and packing
before you use the appliance. You are
advised to keep all transit devices so t
hat they can be refitted if the appliance
ever has to be transported again.
2
1
• After removing all the
packaging, carefully
lay the appliance on
it's back to remove
the polystyrene base
from the bottom.
• Remove the power
supply cable and the
draining hose from the
hose holders on the
rear of the appliance.
• Unscrew the three
bolts.
SERVICE
We recommend the use of original spare parts.
When contacting the Authorised Service Centre,
make sure that these data are available. You can
find the information on the rating plate: model, PNC
and Serial Number. (Mod., Prod. No., Ser. No.)
POSITIONNING
• Install the machine on a flat hard floor. Make
sure that air circulation around the appliance is
not impeded by carpets, rugs etc.
• Check that the machine does not touch the wall
or other kitchen units.
• Slide out the relevant
plastic spacers.
• Remove the polystyr-
ene block fitted on the
door seal. Pull out all
items from the drum.
• Fill the smaller upper
hole and the two large
ones with the plastic
plug caps supplied in
the bag with the User
Manual.
21