Emerson PMAC II Solo Installation And Operation Manual page 18

9. From the Status View screen, press the
button to move the cursor to 4. VIEW MIN
DEWPOINT and press the
lect and view.
MIN DEW POINT
Figure 1-44 - Minimum Dewpoint Status Screen
This screen displays the minimum dewpoint setpoint.
10. Press the
Status View screen.
11. From the Status View screen, press the
button to move the cursor to 5. VIEW MAX
DEWPOINT and press the
lect and view.
MAX DEW POINT
80F
Figure 1-45 - Maximum Dewpoint Status Screen
This screen displays the maximum dewpoint setpoint.
12. Press the
Status View screen.
13. From the Status View screen, press the
button to move the cursor to 6. VIEW MIN
PULSE % and press the
and view.
MIN PULSE RATE
10%
Figure 1-46 - Minimum Pulse Rate Status Screen
This screen displays the minimum pulse rate generated
at the minimum dewpoint setpoint.
Programming the UC12PG-R Controller on the PMAC II Solo Panel
button to se-
16F
or button to go back to the
button to se-
or button to go back to the
button to select
14. Press the
Status View screen.
15. From the Status View screen, press the
button to move the cursor to 7. VIEW MAX
PULSE % and press the
and view.
MAX PULSE RATE
100%
Figure 1-47 - Minimum Pulse Rate Status Screen
This screen displays the maximum pulse rate generated
at the maximum dewpoint setpoint.
16. Press the
Status View screen.
17. From the Status View screen, press the
button to move the cursor to 8. VIEW LOAD
SHED and press the
view.
LOAD SHED STATUS
INACTIVE [X]
Figure 1-48 - Load Shed Status Screen
This screen displays the state of the load shed input.
The load shed input is active on a closure and inactive when
open.
18. Press the
Status View screen.
19. From the Status View screen, press the
button to move the cursor to 
9. V IEW LOAD SHED %. Press the
button to select and view.
or button to go back to the
button to select
or button to go back to the
button to select and
or button to go back to the
Overview • 12