Dell EMC ECS EX Series Hardware Manual page 62

EX3000 Platform
Item Indicator, Button, or
Connector
1 Blade EN connector
(optional)
2 Serial connector
3 Video connector
4 Ethernet connector 1
5 Ethernet connector 2
6 USB connector
7 SD vFlash card slot
8 USB connector
9 Dedicated Ethernet port
10 System identification button
11 Ethernet connector 3
12 Ethernet connector 4
13 Power button
14 Boot HDD A
15 Boot HDD B
16 Power supply units
17 Power supply units
ECS EX-Series Hardware Guide
62
Table 18 Server indicators, buttons, or connectors
Description
This function is reserved.
Enables you to connect a serial device to the system.
Enables you to connect a VGA display to the system.
Integrated 10/100/1000 Mbps NIC connector.
Integrated 10/100/1000 Mbps NIC connector.
Enables you to connect USB devices to the system. The port is USB 2.0-
compliant.
Provides persistent on-demand local storage and a custom deployment
environment that allows automation of server configuration, scripts and
imaging. For more information, see the
Controller 9 (iDRAC9) User's
Enables you to connect USB devices to the system. The port is USB 3.0-
compliant.
Dedicated management port on the iDRAC ports card.
The identification button can be used to locate a particular system within a
rack.
Press to toggle the system ID on and off.
If the system stops responding during POST, press and hold the system ID
button for more than five seconds to enter BIOS progress mode.
To reset iDRAC (if not disabled in F2 iDRAC setup) press and hold the
button for more than 15 seconds.
Integrated 10/100/1000 Mbps NIC connector.
Integrated 10/100/1000 Mbps NIC connector.
The power button controls the PSU output to the system.
Note: On ACPI-compliant operating systems (OSs), turning off the system
using the power button causes the system to perform a graceful shutdown
before power to the system is turned off.
2.5-inch boot HDD
2.5-inch boot HDD
Two redundant power supply units (PSUs) for sled A.
Two redundant power supply units (PSUs) for sled B.
Note: Features of sled B are for EX3000D dual-node systems only.
Note: A dummy sled (sled B) will be installed over the sled A compartment and
two dummy PSUs over the PSU slots for sled B in the EX3000S single-node
system.
Integrated Dell Remote Access
Guide.