Samsung AM FN1DEH Series Installation Manual page 45

Abnormal condition
1. COND mid sensor is detached
2. Refrigerant leakage (2nd detection)
3. Abnomally high temperature on Cond (2nd detection)
4. Low pressure s/w (2nd detection)
5. Abnomally high temperature on discharged air on outdoor unit (2nd
detection)
6. Indoor operation stop due to unconfirmed error on outdoor unit
7. Error due to reverse phase detection
8. Comp stop due to freeze detection (6th detection)
9. High pressure sensor is detached
10. Low pressure sensor is detached
11. Outdoor unit copression ration error
12. Outdoor sump down_1 prevetion control
13. Compressor down due to low pressure sensor prevention control_1
14. Simultaneous opening of cooling/heating MCU SOL valve
(1st detection)
15. Simultaneous opening of cooling/heating MCU SOL valve (2nd
detection)
Other outdoor unit self-diagnosis error that is not on the above list
Flowating s/w (2nd detection)
EEPROM error
EEPROM option error
Error due to incompatible indoor unit
● On
X Off
Flickering
• If you turn off the air conditioner when the LED is flickering, the LED is also turned off.
• If you re-operate the air conditioner, it operates normally at first, then detect an error again.
• When E108 error occurs, change the address and reset the system.
Ex.) When address of the indoor unit #1 and #2 are set as 5, address of the indoor unit #1 will become 5 and indoor
unit #2 will display E108, A002.
• When error occurs on AM✴✴✴JN1DEH✴ model, open the horizontal blade to see the LED.
* The LED color of AM✴✴✴JN1DEH✴ model
4 Way cassette
Abnormal condition
Error on indoor temperature sensor (Short or Open)
1. Error on Eva-in sensor (Short or Open)
2. Error on Eva-out sensor (Short or Open)
3. Discharge sensor error (Short or Open)
LED Display
Error
code
Green Red
(*Ice (*Yellow
Blue) Green)
E241
E554
E450
E451
E416
E559
E425
E403
X X
E301
E306
E428
E413
E410
E180
E181
E153
X X
E162
E163
E164
X X
LED Display
Error code
Operation Defrost
E121
X
E122
E123
E126
X
X X
Timer Filter
X X
X X
45