Spare Parts; Ordering Data; Replacing Rolling-Contact Bearings; Using Commercially Available Spare Parts - Siemens H-compact PLUS Operating Instructions Manual

Spare Parts

10.1

Ordering data

When ordering spare parts, in addition to the precise designation of the spare part, specify
the motor type and the serial number of the motor. Ensure that the spare part designation
matches the designation in the spare part lists and add the associated part number.
Example:
Bearing shield, drive end (Part 5.00)
Motor type 1RQ6
Serial number N-WOGeneric TEAAC000010001
The machine type and the serial number are indicated on the rating plate and in the technical
data, and are also embossed on the drive end of the shaft.
The graphical representations in this chapter show schematic diagrams of the basic
versions. They are used for spare parts definitions. The supplied version may differ in details
from these representations.
10.2

Replacing rolling-contact bearings

When ordering rolling-contact bearings, in addition to the bearing identification code, the
supplementary specifying code is also necessary for the bearing version. Both of these
codes are stamped on the lubricant plate and specified in the motor documentation, or can
also be taken from the installed bearings.
NOTICE
Insulating rolling-contact bearings
If rolling-contact bearings with an insulated outer ring are installed, then you must reinstall
such bearings in order to avoid any damage caused by bearing currents.
10.3

Using commercially available spare parts

You can use commercially available, standard components, but ensure that they have the
same construction type, dimensions, strength class etc.
WOGeneric TEAAC / 2008
Siemens AG Operating Instructions 1.03 1RQ671...-Z
10
59