Table of Contents
Advertisement
Device setup
2.
Whilst the device is in linking
mode, switch the 'learn' slider on
the sensor to the 'set' or 'del'
position (either is fine). This action
will send out a command to unlink
the LightwaveRF device.
3.
The LED on the LightwaveRF
device
receiving
should flash to indicate that the
unlinking
attempt
successful.
Setting the light level
IMPORTANT: To promote reliable operation, try to ensure that the Dusk to
Dawn Sensor is positioned where it will not be a ected directly by bright,
artificial lights that will interfere with the sensor.
Setting the light level alters the preset at which the sensor will automatically
turns on/o LightwaveRF devices. The level can be set by pressing the
'start' button which activates the sensor. There are two methods:
the
command
has
been
Advertisement
Table of Contents
