Table of Contents
Advertisement
Device setup
2.
Whilst the LightwaveRF device is in
linking mode, switch the 'learn' slider
on the sensor to the 'del' or 'set'
position (either is ok). This action will
send out a command instructing the
sensor to link to the device. Repeat
this
step
to
link
to
as
many
LightwaveRF devices as desired.
3.
The LED on the LightwaveRF
device receiving the linking command
should flash to indicate that the linking
attempt has been successful.
Unlinking the sensor from a
LightwaveRF device
1.
Place the LightwaveRF device that
you wish to remove in 'linking' mode.
For information on how to do this
please refer to the instruction manual
for that specific LightwaveRF device.
Advertisement
Table of Contents
