Table of Contents
Advertisement
Device setup
1.
Press and release the 'start'
button. This will instruct the sensor
to send out an on or o
when light levels reach the factory
preset (10 lux).
2.
Hold the 'start' button for 3
seconds (sensor light will flash for
several seconds). This will instruct
the sensor to learn the current light
level in its immediate environment
and use this level to trigger devices.
Setting the time delay
The time delay function consists of
a rotary switch with preset hour
marks. If the switch is set to '0',
then there is no time delay set. The
sensor
will
LightwaveRF device once the light
level has gone below/above that
setup by the user.
command
turn
on/o
any
Advertisement
Table of Contents
