Device setup
Inserting the Batteries
The battery compartment is accessed
from the rear of the switch beneath
the cover. 2 x AAA batteries are
required (not included). Once fresh
batteries have been inserted, the start
button
must
be
pressed
to
(re)activate the sensor.
NOTE: When the batteries are low, the
Sensor light will flash every 3 seconds.
Linking the sensor to a
LightwaveRF device
1.
Place the LightwaveRF device that
you wish to control (e.g. Dimmer) in
'linking' mode. For information on how
to
do
this
please
refer
to
the
instruction manual for that specific
LightwaveRF device.