Using The Extractor Hood As An Exhaust Air Hood; Converting The Extractor Hood To A Circulation Hood; Lectrical Connection - KKT KOLBE Profi Series User Manual

Installation
!
Only connect the appliance to the power
supply once it is properly installed.
. Using the extractor hood as
an exhaust air hood with air
extracted to outdoors
If the extractor hood has been itted at
the factory with a carbon ilter, this must
be removed. It is only practicable to use
this when operating your hood in circu-
lation mode.
. Converting the extractor
hood to a circulation hood
If you wish to use an appropriately itted
hood as a circulation hood, you must
mount the active carbon ilter s to the
fan motor before using the hood. The ac-
tive carbon ilter s is/are included in the
scope of supply with some models.
Otherwise you must obtain the active
carbon ilter s from the supplier of your
extractor hood. )ou must also change
your hood over to the „'ilter position" at
the device provided lever or ball hand-
le .
. Electrical connection
Before connecting the extractor hood,
check that the voltage stated on the ra-
ting plate V agrees with the supply vol-
tage in your home.
Gewerbliches inhaltliches Kopieren verboten! Gewerbliches inhaltliches Kopieren verboten!
Never install the appliance if the data
on the rating plate does not agree with
your supply voltage.
)ou will ind the rating plate inside the
appliance, behind the grease ilter.
If the extractor hood is itted with a
standard connector plug, connect this
to an easily accessible standard socket.
If the appliance is not itted with a con-
nector plug, a two-pole switch, confor-
ming to standards with a minimum open
contact gap of mm is to be installed by
an authorized tradesman in an easily ac-
cessible location.
. Mounting the carbon ilter
)ou will ind the mounting instructions
for the carbon ilter in its packaging. To
mount the carbon ilter, remove the gre-
ase ilter s , it the carbon ilter according
to its mounting instructions and reit the
grease ilter s .