MSI Wind Board D510 Series Manual page 37

▶ Quick Booting Quick Booting
Setting the item to [Enabled] allows the system to boot within 10 seconds since it will
skip some check items.
▶ Boot Up Num-Lock LED Boot Up Num-Lock LED
This setting is to set the Num Lock status when the system is powered on. Setting to
[On] will turn on the Num Lock key when the system is powered on. Setting to [Off ] will
allow users to use the arrow keys on the numeric keypad.
▶ IOAPIC Function IOAPIC Function
This fi eld is used to enable or disable the APIC (Advanced Programmable Interrupt
Controller). Due to compliance with PC2001 design guide, the system is able to run in
APIC mode. Enabling APIC mode will expand available IRQ resources for the system.
▶ MPS Table Version MPS Table Version
This fi eld allows you to select which MPS (Multi-Processor Specifi cation) version to be
used for the operating system. You need to select the MPS version supported by your
operating system. To fi nd out which version to use, consult the vendor of your operating
system.
▶ Primary Graphic's Adapter Primary Graphic's Adapter
This setting specifi es which graphic card is your primary graphics adapter.
▶ PCI Latency Timer PCI Latency Timer
This item controls how long each PCI device can hold the bus before another takes
over. When set to higher values, every PCI device can conduct transactions for a longer
time and thus improve the eff ective PCI bandwidth. For better PCI performance, you
should set the item to higher values.
▶ HPET HPET
The HPET (High Precision Event Timers) is a component that is part of the chipset. You
can to enable it, and will provide you with the means to get to it via the various ACPI
methods.
▶ VGA Share Memory VGA Share Memory
The system shares memory to the onboard VGA card. This setting controls the exact
memory size shared to the VGA card.
▶ DVMT Mode Select DVMT Mode Select
This item allows you to set the mode for the graphics core..
[Fixed] a fi xed-size fragment of the system memory is allocated to the
graphics core. It can only be used by the graphics core.
[DVMT] the driver of the graphics core uses the system memory like any
other OS component or application does.
▶ DVMT/Fixed Memory DVMT/Fixed Memory
Specify the size of DVMT/FIXED memory to allocate for video memory.
▶ Clearing the TPM Clearing the TPM
Press Enter to clear the TPM status.
▶ TCG/TPM Support TCG/TPM Support
Setting the option to [Yes] enables TPM (Trusted Platform Module) for the system.
MS-7618
3-9