IBC SFC-99 Installation And Operating Instructions Manual page 2

WARNING
If the information in this
manual is not followed
exactly, a fire or explosion
may result causing property
damage, personal injury, or
loss of life.
2
SFC COMBI BOILERS SFC-99, SFC-125
SAFETY CONSIDERATIONS
Installation, start-up and servicing of IBC units must be done with due
care and attention, and should only be performed by competent, qualified,
licensed and trained heating technicians. Failure to read and comply with
all instructions and applicable National and local codes may result in
hazardous conditions that could result in property damage and injury to
occupants which in extreme cases might result in death.
HAZARDS & PRECAUTIONS
DANGER
Points out an immediately
hazardous situation which
must be avoided in order to
prevent serious injury or
death.
CAUTION
Points out a potentially
hazardous situation which
must be avoided to prevent
possible moderate injury and/
or property damage
BEST PRACTICES
Points out recommendations
for better installation.
Supplied with the unit - The SFC unit is shipped with an accessory parts kit
consisting of the following items:
•
1 x Wall Mounting Bracket, 4 x 1.75 " bolts - IBC part P-837
•
1 x Condensate Trap Assembly
•
1 x Pressure Relief valve, ¾ NPT, 30psi
•
1 x Outdoor Temperature Sensor, IBC part P-732
•
1 x SFC Installation & Operating Instructions
•
1 x SFC/SFB Controller Manual
•
1 x Propane Conversion Kit: P-804 (SFC-99) or P-806 (SFC-125)
WARNING
Points out a potentially
hazardous situation which
must be avoided to prevent
serious injury or death.
NOTE
Points out installation,
maintenance and operation
details that will result in
enhanced efficiency, longevity
and proper operation of your
unit.
INSTALLATION AND OPERATION INSTRUCTIONS