Page 1
• If you cannot reach your gas supplier, call the fire department. Installation and service must be performed by a qualified installer, service agency or the gas supplier. This Manual is also available in French - contact IBC or visit our web site www.ibcboiler.com www.ibcboiler.com...
SAFETY CONSIDERATIONS WARNING If the information in this Installation, start-up and servicing of IBC boilers must be done with due manual is not followed exactly, a fire or explosion care and attention, and should only be performed by competent, qualified, may result causing property licensed and trained heating technicians.
WARNING Water quality has a significant HOT WATER CAN SCALD! impact on the lifetime and Water Temperatures over performance of an IBC Boiler 125°F / 52°C can cause severe heat exchanger. burns instantly or death from Improperly prepared water in scalds.
Page 5
SL SERIES BOILERS DANGER WARNING Should overheating occur Do not use this boiler if any or the gas supply fails to part has been under water. shut off, do not turn off or Immediately call a qualified disconnect the electrical service technician to inspect supply to the pump.
Load Combining – simultaneous operation of 2 similar water temperature loads • The control can manage and/or operate in a network of up to 24 IBC VFC or SL boilers Some of the new features available in the touch screen control include: •...
SL SERIES BOILERS Control Interface The control interface is provided through a 2-1/4 x 4 inch, color Touch Screen display. The Touch Screen responds to a light finger touch on the screen. You can also use a stylus or similar device to operate the touch controls. Do not use a sharp or metallic object such as a screw driver to operate the control as it could damage the touch screen.
SL SERIES BOILERS MAINTENANCE WARNING Annual Maintenance must only be done by a qualified service Daily Maintenance technician. • Check the surrounding area – inspect for water leaks in the general area around the boiler and boiler piping CAUTION •...
Page 10
SL SERIES BOILERS Relief Valve - Maintenance and Testing CAUTION The relief valve manufacturer requires that under normal operating conditions Before testing the relief valve, a “try lever test” must be performed every two months. Under severe service make certain the discharge...
SL SERIES BOILERS SERVICE RECORD DATE LICENSED CONTRACTOR DESCRIPTION OF WORK DONE USER’S INFORMATION MANUAL...
Page 12
SL SERIES BOILERS NOTES USER’S INFORMATION MANUAL...
Page 13
SL SERIES BOILERS NOTES USER’S INFORMATION MANUAL...
Page 14
• This boiler is part of a modular or multiple boiler system having a total input 300,000 BTU/hr or greater. • This boiler is equipped with a tankless coil (not applicable to IBC’s SL boilers). US installers should contact IBC for any further information required.