Table of Contents
Advertisement
Inspection & Review
Before beginning the installation, Inspect the engine to be upgraded and
verify the following are in good working order:
- Pick-up rollers
- Motor w/flywheels
- Smoke unit
(if equipped)
- Speaker mounting hardware
- Volume pot
- Coupler mounting hardware,
"T" bar, spring, c-clip
- Constant voltage lighting board
and connected bulbs.
Note:
If any of the above items are
missing or not in working order,
procure the required parts before
continuing.
It might be helpful to label the
Note:
Front and rear of the chassis as a
reminder which direction the engine
should first move when powered up.
Make sure pickup rollers are clean and roll freely.
PS-2 Upgrade Kit Installation Guide
Note: Before beginning
installation, see discussion
on page 27 on "wire
management" which should
be planned as you proceed
during the installation. Part
of the plastic wire tube (Q)
may be used for this
purpose.
9
Advertisement
Table of Contents
