Table of Contents
Advertisement
Conventional PS-2 Operation
This manual contains the operating instructions for Proto-Sound 2.0 in
conventional mode only. Instructions for accessing DCS command mode
features accompany the DCS Remote Control System equipment.
Activating Features
Throttle
To increase or decrease track voltage, and therefore train speed, turn
the throttle control knob. Turning clockwise will increase voltage and speed,
while turning counterclockwise will decrease voltage and speed. The engine
will maintain the speed you set after you release the throttle until you turn it
again to change the voltage and speed.
- To sound the bell, in an engine equipped with a bell firmly press and
Bell
release the Bell button. To turn the bell off, press and release the Bell button
again. The bell will continue to ring from the time you turn it on until you press
and release the button again to turn it off.
Horn/Whistle
- To sound the whistle, firmly press the Horn/Whistle button. The
whistle will sound for as long as you continue to depress the button. It will stop
when you release the button.
Direction
Your train is programmed to start in neutral. The train will always
cycle neutral-forward-neutral-reverse with each press and release of the
direction button. The engine is programmed to restart in neutral each time the
track voltage is turned off for 25 seconds or more. Manual Volume Control
To adjust the volume of all sounds made by this engine, turn the master volume
control knob located under the left water hatch on the tender deck clockwise to
increase the volume and counter-clockwise to decrease the volume.
Cycle Phases
Neutral
Reverse
Neutral
32
Forward
PS-2 Upgrade Kit Installation Guide
Advertisement
Table of Contents
