Mounting The Ps-2 Board - DCS Proto-Sound 2.0 Diesel/Electric Locomotive Upgrade Kit Installation Manual

Mounting The PS-2 Board

-Remove the PS-2 Board (A) from the
sealed anti-static bag
-Verify PS-2 board is securely inserted
into its plastic mounting bracket.
NOTE: If you are not a
participating MTH
Authorized Service Center
there is NO warranty once
the bag is opened
NOTE: Use ESD safe work
area and procedures when
handling the PS-2 board.
- Remove the speaker (H) from the
protective packaging
careful not to damage the speaker
cone).
- Place the PS-2 board/plastic
mounting bracket (A) on the chassis
to verify the best location to
mount the plastic mounting bracket
and the metal heat sink bracket
(AA) to the chassis. Also locate
a place to put the battery pack (I)
And battery charging jack (II).
12
(NOTE: be
PS-2 Upgrade Kit Installation Guide
Make sure the PS-2 board is firmly inserted
into the plastic mounting bracket. If not,
gently push the board into the bracket until
fully "captured" by the bracket. DO NOT
REMOVE THE BOARD FROM THE
.
BRACKET
Place the components on the chassis floor
in the best position given the space. It
may be necessary to turn the battery pack
on its side as seen above.
Note: Position the battery pack close
enough to the PS-2 board so it does
require lengthening of the battery pack or
battery recharging port harnesses.
Lengthening either of these harnesses will
reduce the battery voltage to the board
and may affect operation.
NOT