Table of Contents
Advertisement
Locking Locomotive Into a Direction
You can lock your engine into a direction (forward, neutral, or reverse) so that it
will not change directions. To do this, put the engine into the direction you
want (or into neutral to lock it into neutral), run it at a very slow crawl (as
slowly as it will move without halting), and quickly but firmly tap the Horn
button once followed by three quick taps of the Bell button, allowing
approximately ½ second to lapse between each quick button press. Two horn
blasts will indicate that the engine has made the change. The engine will not
change direction (including going into neutral) until you repeat the 1 horn, 3
bells code to return the engine to its normal condition, even if the engine is kept
without power for extended periods of time.
Place
Engine into
Horn
Horn
Desired
Direction
Reset To Factory Default
To override the settings you currently have assigned to the engine and reset it to
its factory defaults, while in Neutral tap the Horn button quickly once, followed
by five quick taps of the Bell button, allowing approximately ½ second to lapse
between each quick button press. Two horn blasts will indicate that the engine
has made the change.
Place
Horn
Engine in
Neutral
Automatic Sound Effects
Certain Proto-Sound 2.0 sound effects automatically play in programmed
conventional mode conditions:
•Squealing Brakes play any time the engine's speed decreases rapidly.
•Cab Chatter plays at random intervals when the engine idles in neutral.
•Engine Start-up and Shut-down sounds play when the engine is initially
powered on or is powered off for five seconds or more.
Bell
Bell
Bell
Bell
Bell
Bell
PS-2 Upgrade Kit Installation Guide
Direction Lock
Two Horn Blasts
=
(indicates change is made)
Repeat to Return
to Normal Condition
=
Bell
Bell
Reset
Two Horn Blasts
(indicates change is made)
Repeat to Return
to Normal Condition
37
Advertisement
Table of Contents
