Table of Contents
Advertisement
Mounting The PS-2 Board Cont'd
- Once you have determined the best
locations for mounting the PS-2
Board bracket (A), metal heat sink
bracket (AA), battery pack (I), and
battery charging jack (II), mark the
chassis floor locations using a pencil
or silver marker so you can drill the
holes in the proper locations. If
necessary, determine the location of
the smoke unit switch as well.
- Remove the PS-2 board with
plastic mounting bracket (A), metal
heat sink bracket (AA), speaker and
battery from the chassis and place
on an ESD safe area on your
workbench. Removing the motors &
trucks will help protect them from
Any stray metal chips when drilling
mounting holes.
- Drill the holes as marked with the
proper drill size. A 5/32" bit will be
required for the PS-2 plastic
mounting bracket (A) and heat sink
bracket (AA). Use a 1/8" bit for the
battery charging jack mounting
holes.
- De-burr the holes slightly using a
larger drill bit (3/8") or a deburring
tool. Clean all metal burrs or chips
from the chassis before proceeding.
PS-2 Upgrade Kit Installation Guide
Drill the appropriate mounting holes as
determined from positioning the PS-2
board and other components
Carefully remove any metal burrs
resulting from drilling the mounting
holes. Loose metal burrs can damage the
PS-2 circuit board!
13
Advertisement
Table of Contents
