Table of Contents
Advertisement
Connecting The PS-2 Harness To The Smoke Unit
-Soldering Gray and Green wires to
the smoke unit fan motor. If the
smoke unit motor terminals are
hooked up backward, the impeller will
spin in reverse and fail to pump out
the smoke. When properly wired, most
impellers should rotate clockwise.
-Cut through the traces on the top of
the smoke unit board.
elements MUST be isolated from
the electronics on the board or the
PS-2 board will be permanently
damaged.
Another alternative is to
cut the printed circuit board such that
the electrical components are no
longer present since the PS-2
hardware will be managing the smoke
unit heating elements and motor-
alternate cut line.
26
The heating
see
PS-2 Upgrade Kit Installation Guide
Green Wire
Gray Wire
Follow the above wiring directions to the
smoke unit motor.
CRITICAL STEP!!
Use a razor saw to cut the bottom of the
smoke unit circuit board, isolating the no
longer required components on the left.
FAILURE TO CUT TRACE
COMPLETELY WILL PERMANENTLY
DAMAGE PS-2 BOARD.
cut is free of debris that could form an
electrical contact.
Make sure saw
Advertisement
Table of Contents
