Westfalia YL-B08 Instruction Manual page 12

1. To adjust the required room temperature, turn the 4
step switch (7) to the position I, II or III. Now turn the
thermostat switch (5) up to the end in clockwise direc-
tion and to HIGH and wait until the required tempera-
ture has been reached.
2. Now turn the thermostat switch slowly back to LOW
until the control light turns off. This thermostat position
corresponds to the required room temperature. As soon
as the room cools down, the radiator will turn on again.
Overheating Protection
To prevent overheating, the built-in thermal overheating protection switches off
the radiator. Overheating may occur if the unit is covered while operation.
1. Turn the 4 step switch up to the end counter clockwise to position 0 and pull
the power plug.
2. First, allow the radiator to cool down for at least 20 minutes. Insert the power
plug again into a grounded wall socket and adjust the room temperature with
the 4 step switch and the thermostat switch.
Anti Tilt Protection
Additionally, the radiator is equipped with anti tilt protection. In case the radiator is
accidentally tilted during operation, the radiator will automatically switch off. Put
the radiator in the upright position again and it will continue heating.
Cleaning and Storing
Unplug from power mains before cleaning the unit.
For cleaning the housing only use a damp cloth. Do not immerse the unit into
liquids. Do not allow water to enter the interior of the unit. Do not use aggres-
sive chemicals or abrasives in order not to damage the surfaces.
Allow the radiator to cool down completely before storing it. Wind the power
cord around the cable storage to avoid tripping hazard.
Operation
7