Operation; Filling The Water Reservoir - Beem SA4.5.1 Manual

EN
When the device is fi rst used, production-related additives (e.g. grease) may cause a
small amount of smoke and / or an odour to be produced. This is normal and not a
device defect.
8. Perform this process twice. Do not drink this water!
9. Clean the device and accessories (see the "Cleaning and Care" chapter).

Operation

NOTES
• Do not attempt to carry the device by the lid handles. Only use the handles on the
water reservoir.
• Do not place the device in the sink or similar in order to fi ll the water reservoir.
Thermostat regulator
The thermostat control (6) is used to switch the device on and off and set the temperature
of the water (Picture C).
Switch on (a) Turn the thermostat control clockwise until it resists.
Switch off (b) Turn the thermostat control counter clockwise until it resists.
The control lamp (10) lights up blue as soon as the heating element of the device starts
heating the water. The control lamp lights blinks when the water is being kept warm and
when boiling at intervals.

Filling the Water Reservoir

Only ever fi ll the water reservoir (5) with fresh, clear tap water. Do not pour in any
other liquids.
1. Hold the lid (3) by the lid handle (13) and pull it upwards.
2. Pour the desired quantity of water (about 5 litres) using a carafe or similar into the
water reservoir. Note the MAX level mark (Picture D).
3. Put the lid back on and carefully secure it. You must hear and feel it close.
Operating the Discharge Tap
1. Press down the lever (12) and keep it pressed down. The discharge tap (11) opens
and water fl ows out from the water reservoir (5) (Picture E).
2. Let go of the lever when the quantity of water you want has been removed. The
discharge tap closes again.
28