Copyright, Limitation Of Liability And Revision Rights; About This Manual; References - GE AF-600 FP Metasys Operating Instructions Manual

AF-600 FP Metasys

1.1.3 Copyright, Limitation of Liability and Revision Rights

1
This publication contains information proprietary to GE. By accepting and using this manual the user agrees that the information contained herein will be used
solely for operating equipment from GE or equipment from other vendors provided that such equipment is intended for communication with GE equipment over
a serial communication link. This publication is protected under the Copyright laws of Denmark and most other countries.
GE does not warrant that a software program produced according to the guidelines provided in this manual will function properly in every physical, hardware or
software environment.
Although GE has tested and reviewed the documentation within this manual, GE makes no warranty or representation, neither expressed nor implied, with respect
to this documentation, including its quality, performance, or fitness for a particular purpose.
In no event shall GE be liable for direct, indirect, special, incidental, or consequential damages arising out of the use, or the inability to use information contained
in this manual, even if advised of the possibility of such damages. In particular, GE is not responsible for any costs, including but not limited to those incurred as
a result of lost profits or revenue, loss or damage of equipment, loss of computer programs, loss of data, the costs to substitute these, or any claims by third
parties.
GE reserves the right to revise this publication at any time and to make changes to its contents without prior notice or any obligation to notify former or present
users of such revisions or changes.
It has been assumed that all devices will be sitting behind a firewall that does packet filtering and the environment has well-implemented restrictions on the
software that can run inside the firewall. All nodes are assumed to be "trusted" nodes.

1.1.4 About this Manual

This manual is for both instructional and for reference purposes. This manual can also serve as a guideline when you specify and optimize your communication
system.
It is highly recommended that you read this manual in its entirety before initiating any programming. It is assumed that the user has full knowledge of the
capabilities and limitation of the controller node in addition to full knowledge of the frequency converter.

1.1.5 References

In addition to this manual, the following two manuals should be consulted: AF-600 FP Operating Instructions and Johnson Controls METASYS N2 System Protocol
Specification for Vendors, Johnson Controls number 04-3402-22, rev A.
4